WORKSHOP 29/12/25

prototype for our can

Things done

• Tested the parachute, by dropping it from the second flore and calculated its final speed. We faced a minor issue, the final speed was way too low ( 3,4m/s and it's supposed to be around 8m/s). We believe that it's due to the limited drop height of two floors. We plan to conduct further tests at a different location with a significantly greater height.

• Prototyped the can by organizing and integrating the different modules. Here, we started thinking about how making our secondary mission work, how letting air in and out of the can in an extremely restrained area while still keeping a sterile environment.

• Verified the correct functioning of the primary mission

• Completed the 3D design of the can

• Started 3D printing the funnel component